沿滑觸線全長在水平與垂直平面內均不應超過10毫米,滑觸線的布置與中心線的誤差.滑觸線相互間距離誤差不應大于10毫米。

Along the sliding contact line length in horizontal and vertical plane should not be more than 10 mm, the error is arranged sliding contact line and the center line. The sliding contact line distance error should be less than 10 mm.

滑觸線分段位置,測試工藝工位的布置決定供電滑觸線上的扁平銅條(導線)整個區間內是分段地,每段之間用絕緣物隔開,物理的分成了通電區和斷電區(非測試區),其中通電區又分為低啟區(供電電壓187v,制熱區和制冷區(供電電壓均為220v滑觸線上的扁平銅條 導線 整個區間內是分段的。

Sliding contact line position, the test process of station layout decided the flat copper bar power supply sliding contact line (wire) within the entire interval is segmented, separated by insulating material between each section, the physical into electricity and power off (non test area), the ohmic region can be divided into low open area the power supply voltage (187v, business zone and the cooling zone (supply voltage are flat copper wires 220V sliding contact line within the entire interval is segmented.

先作些感性認知:鋁電解多功能天車負荷繼續率為65%.滑觸線裝置時的環境溫度,作為設計難于預測,對滑觸線制作、裝置的平行度、水平度在國家規范的施工驗收規范中無明確規定;鋁電解特定環境中伸縮縫數量設置不夠的情況下,運行中因檢修或事故造成滑觸線全線停電時有發生。

To make some perceptual cognition: aluminum electrolytic multifunctional crane load to rate of 65%. sliding contact line device when the environment temperature, as the design is difficult to predict, the sliding contact line production, equipment, level of parallelism in the code for construction and acceptance of the norms of the state without explicit provisions; condition number is not set expansion joints of aluminium electrolysis in a specific environment, operation due to maintenance or accidents caused by the sliding contact line power outages have occurred.